Two colleagues shaking hands in an office, welcoming a new employee as part of onboardingA structured onboarding checklist helps new starters settle in quickly and confidently

Most small employers treat probation as a safety net: hire someone, and part ways quickly if it does not work out. That picture is only half true. Probation is a contract term, not a legal status. It changes your notice period and your internal process. It does not switch off employment rights. From 1 January 2027 it will matter far more, because the unfair dismissal qualifying period falls from two years to six months.

This guide covers what probation is, how long to set it, what your contract must say, which rights still apply from day one, and what to do when probation ends.

What a probation period is (and what it is not)

A probation period is a set time at the start of employment when you assess whether the new starter suits the role. Acas says there is no legal requirement to have one, and that it can be any length of time. Section 1 of the Employment Rights Act 1996 defines a probationary period as a temporary period, specified in the contract, meant to let the employer assess the worker’s suitability.

Probation is not a trial shift. The person is a full employee from day one, with a contract, pay and holiday like everyone else. It is not a way to pay less than the National Minimum Wage or to delay holiday. And it is not a free pass to dismiss someone for any reason. Discrimination and whistleblowing protections apply from the first day of work.

What probation gives you is practical. It sets a shorter notice period than the permanent terms, commonly one week instead of one month, and it gives you a formal review point at which you decide whether to confirm the role.

How long should probation last?

UK law sets no minimum and no maximum length. The contract decides. Most small businesses use three to six months. Three months suits straightforward roles, such as retail or admin. Six months suits roles that need training, such as skilled trades.

The length matters more from 1 January 2027. Once unfair dismissal protection starts after six months of service, a six-month probation ending the same week leaves no margin if the final review slips by a fortnight. Three or four months, with a right to extend by a month or two, gives you a real decision point while you still have room to act.

What the contract must say

Since 6 April 2020, the written statement of employment particulars must record any probationary period, including its duration and conditions. That is section 1(4)(ga) of the Employment Rights Act 1996. Probation cannot live in a verbal understanding or an offer letter the contract never mentions.

Your contract should cover five points: the length of probation and its end date; whether you can extend it, and by how much; the notice period during probation, for both sides; what happens at the end; and whether any benefits are delayed, and until when.

One clause causes more disputes than any other: what happens if you do nothing when probation ends. Say it plainly. Either probation ends automatically on the stated date unless extended in writing, or employment is not confirmed until you say so in writing.

Rights that still apply from day one

Probation does not remove any of these:

National Minimum Wage and National Living Wage. The rate depends on age and apprentice status, not on probation. A lower “probation rate” is unlawful.

Paid holiday. Holiday accrues from the first day under the Working Time Regulations 1998. A new starter on a 28-day entitlement accrues roughly 2.33 days per month worked.

Statutory Sick Pay. Once the employee meets the qualifying conditions, SSP is payable in the usual way. Probation does not delay it.

Protection from discrimination. The Equality Act 2010 applies from day one. Dismissing someone during probation because of a protected characteristic, such as disability, pregnancy, race or religion, is unlawful.

Whistleblowing protection. Dismissing someone for raising a protected concern is automatically unfair from day one, with no qualifying period.

The only protection that depends on length of service is ordinary unfair dismissal, which needs two years today and changes on 1 January 2027.

A review schedule that actually works

The most common probation failure is not a bad hire. It is a good hire who was never told what was expected, then failed a review they did not see coming.

Week one: settle in. Confirm the person has their contract, written statement, safety induction and a named person to ask questions. Our new starter legal compliance checklist covers the day-one paperwork in full.

Week four: first check-in. A 30-minute conversation, not a formal hearing. Ask how they are finding the work and what is unclear. Tell them plainly what is going well and what needs to improve, with examples.

Midpoint: formal review. Review them against the standards you set at the start. If there are concerns, say so now. Agree specific improvements and set a date to check again.

Two weeks before the end: final decision review. Do not leave this to the last day. Hold the final review a fortnight before probation ends, so you have time to confirm in writing, extend, or end employment cleanly. Decide on the evidence from the earlier reviews, not on a gut feeling in the final meeting.

Extending probation

Extension is a normal outcome, not a failure. Someone borderline at three months may be solid at five. But you can only extend if the contract allows it, so check the clause before you rely on it. If the contract says nothing about extension, you need the employee’s agreement in writing.

When you extend, put the new end date in writing and say exactly what needs to improve and how you will measure it. A typical extension is one to three months. Do not use extension to avoid a decision. If the evidence is clear that the person cannot do the job, extending only delays the conversation.

Confirming, or ending, employment

At the end of probation, confirm the employee, extend probation, or end employment. Ending employment during probation still needs care. First, give the correct notice. The statutory minimum under section 86 of the Employment Rights Act 1996 is one week once the employee has one month of continuous service, and it applies to both sides. In the first month there is no statutory minimum, so the contract governs. Your contract can require longer notice than the statutory minimum, but never less.

Second, hold a meeting and explain the reasons, with examples from the review notes. You are not required to follow a full disciplinary procedure for someone with under two years’ service today, but a short, fair meeting is good practice. Third, pay what is owed: salary to the leaving date, accrued but untaken holiday, and notice pay or payment in lieu of notice if the contract allows it. Confirm the leaving date and the final pay in writing on the same day.

Note the contrast with redundancy. Ending a failed probation is about one person’s suitability for one role. A redundancy process is about the role itself disappearing. Do not dress one up as the other.

The 1 January 2027 change: why your timing matters now

The Employment Rights Act 2025 received Royal Assent on 18 December 2025. The change that matters most for probation is the unfair dismissal qualifying period. For dismissals taking effect on or after 1 January 2027, an employee needs only six months of continuous employment to bring an ordinary unfair dismissal claim. That is down from two years today. The change applies to people already on your payroll, so anyone with six months of service on 1 January 2027 gains protection that day.

The practical consequences are direct. A person hired in July 2026 will already have six months of service on 1 January 2027. They gain full protection that day. A dismissal handled casually at seven months of service now carries the full risk of an ordinary unfair dismissal claim.

Take three steps before the change bites. First, move new starters to a three or four-month probation with a right to extend. Second, bring forward the final reviews of everyone hired in the second half of 2026 to before 1 January 2027 where possible. Third, check that every contract records the probationary period and its conditions. The Act does not create a statutory probation period, and Acas says so. An earlier nine-month proposal was dropped. The six-month qualifying period is the confirmed change.

Common mistakes small employers make

Treating probation as a right to dismiss for any reason. Discrimination, whistleblowing and health and safety protections apply from day one.

Setting probation and never reviewing it. A six-month probation with no reviews until week 24 is a surprise, not a process.

Forgetting to confirm or extend in writing. If probation ends and nothing is said, the employee may be treated as confirmed by implication.

Ignoring the 2027 calendar. A probation policy written when two years’ service was the threshold is now out of date.

A probation period works when it is written down, reviewed on schedule and decided on evidence. Put the length, the notice period and the extension right in the contract before the person starts, and make the final decision two weeks before the end date. If you are employing staff for the first time, start with the hiring checklist, then use this guide alongside your employee onboarding checklist so the new starter’s first months are covered from every angle.

Related reading

Corporation tax marginal relief for UK small companies

Dividends vs salary for limited company directors

Making Tax Digital for Income Tax: self-employed guide 2026

VAT registration threshold UK